This error code indicates a problem with the oven's temperature sensor (RTD probe) or its electrical connection. The oven cannot accurately read cooking temperature, preventing it from operating safely.
• Oven will not heat or maintain temperature
• Display shows F2 error code and beeps repeatedly
• Oven may shut off mid-cycle
• Cooking times are inconsistent or food cooks unevenly
• Control panel may become unresponsive
• Error persists even after closing and reopening the oven door
🔧
Possible Causes
• Temperature sensor (RTD probe) is damaged, broken, or worn out
• Temperature sensor connector is loose or corroded
• Wiring harness connected to the temperature sensor is damaged
• Control board cannot communicate with the temperature sensor due to electrical fault
• Sensor probe has accumulated grease or food buildup affecting readings
• Power supply voltage fluctuations (common with 240V US models) damaged the sensor circuit
• Defective electronic control board unable to read sensor signals
✅
Safety Checks You Can Do
• Turn off the oven and allow it to cool completely for at least 30 minutes
• Check that your home's circuit breaker for the oven is in the ON position; if tripped, turn it OFF then back ON
• Verify the oven door closes completely and latches properly with no gaps
• Inspect that no racks or cookware are blocking the oven cavity
• Clear any visible food debris, grease, or buildup from the oven interior
• Confirm all control panel buttons and settings are functioning normally
• Perform a hard reset: locate your oven's dedicated circuit breaker, switch it OFF, wait 60 seconds, then switch it back ON
• Allow the oven to sit powered for 5 minutes before attempting to use it again
• If error clears after reset, test with a short baking cycle at 350°F to confirm normal operation
• If F2 error returns, contact on 844-731-2978 for Asko service technician—internal sensor or control board repair is required
⚠️
NOTE!
If the error code persists, call to schedule your service
Need Professional Assistance?
Our expert technicians are ready to help you with any service needs.
