Book Now

Asko Oven Error Code F10

Error code F10 indicates a problem with the oven's temperature sensor or its electrical connection, preventing the oven from accurately monitoring cooking temperature. This error typically prevents the oven from operating until the issue is resolved.

Home Services
⚠️

Problems You May Notice

    • Oven will not heat or reach set temperature • Error code F10 displays on the control panel • Oven beeps and locks out operation • Display may show flashing F10 code • Heating elements do not activate • Oven remains unresponsive to temperature settings
🔧

Possible Causes

    • Malfunctioning oven temperature sensor (RTD probe) • Loose or disconnected sensor wiring harness • Damaged sensor connector or broken wire • Corroded electrical connections on the sensor circuit • Control board failure or malfunction • Thermal sensor short circuit or open circuit condition • 240V power supply issue affecting sensor circuit • Manufacturing defect in temperature sensing component
✅

Safety Checks You Can Do

    • Check your home's circuit breaker panel - ensure the breaker for the oven is in the ON position; if tripped, switch OFF then back ON • Visually inspect the oven door to confirm it closes completely and latches properly • Review your oven's control panel settings and ensure no lock or demo mode is activated • Allow the oven to cool completely for 30 minutes before attempting to use it again • Perform a full reset: Turn OFF the circuit breaker serving the oven for exactly 60 seconds, then switch it back ON • Attempt to preheat the oven to a low temperature (around 300°F) and wait 5 minutes to see if the error clears • If the error persists after these steps, discontinue use and contact a qualified appliance technician for professional diagnosis and repair
⚠️

NOTE!

If the error code persists, call to schedule your service

Need Professional Assistance?

Our expert technicians are ready to help you with any service needs.

📞 Schedule Service 🔍 Contact Us