Book Now

Asko Refrigerator Error Code E14

Error code E14 on Asko refrigerators indicates a temperature sensor malfunction or communication failure between the control board and temperature detection system. This error prevents the refrigerator from accurately monitoring and maintaining proper cooling temperatures.

Home Services
⚠️

Problems You May Notice

    • Refrigerator not cooling to set temperature • Freezer compartment too warm or not freezing • Digital display showing E14 error code • Inconsistent temperature cycling • Compressor running continuously without reaching target temperature • Food spoiling faster than normal • Ice cream melting in freezer section • Refrigerator running excessively loud or frequently cycling on/off
🔧

Possible Causes

    • Faulty temperature sensor in refrigerator or freezer compartment • Loose or disconnected wire harness between sensor and control board • Control board circuit failure unable to read sensor signals • Ice buildup on temperature sensor probe • Defrost cycle malfunction preventing proper sensor operation • Damaged sensor connector or corroded terminals • Failed thermistor component in the temperature sensing system • 120V power supply fluctuation affecting sensor calibration (USA electrical standard) • Water infiltration into sensor housing from condensation
✅

Safety Checks You Can Do

    • Check your home circuit breaker to ensure the dedicated refrigerator circuit is ON and not tripped • Verify the refrigerator power cord is fully seated in the wall outlet and outlet is functioning properly • Ensure refrigerator door closes completely and seals properly with no gaps • Confirm refrigerator and freezer temperature settings are adjusted correctly on the control panel • Allow the refrigerator 2-4 hours to stabilize temperature after first plugging in or after error appears • Perform a hard reset by turning OFF the circuit breaker for 60 seconds, then switch back ON and wait 5 minutes for system reboot • Check that refrigerator is not in Demo mode or sabbath mode on the control panel settings • Ensure proper airflow around the refrigerator with at least 2 inches clearance on sides and back • Verify condenser coils are not blocked by dust (check visible areas without disassembly) • Listen for compressor operation to confirm refrigeration cycle is attempting to run
⚠️

NOTE!

If the error code persists, call to schedule your service

Need Professional Assistance?

Our expert technicians are ready to help you with any service needs.

📞 Schedule Service 🔍 Contact Us