Book Now

Asko Refrigerator Error Code E15

Error code E15 on Asko refrigerators sold in the USA typically indicates a temperature sensor malfunction or communication error between the control board and the temperature sensing components. This error prevents the refrigerator from properly monitoring and regulating internal temperatures.

Home Services
⚠️

Problems You May Notice

    • Refrigerator not cooling to set temperature • Freezer section displaying incorrect temperature readings • Control panel displaying E15 error message • Inconsistent cooling cycles • Compressor running continuously or not running at all • Food items not staying cold as expected • Audible beeping or alarm sounds from the appliance
🔧

Possible Causes

    • Faulty temperature sensor (thermistor) in refrigerator or freezer compartment • Loose or disconnected wiring harness between control board and temperature sensors • Malfunctioning electronic control board • Corroded sensor connectors due to humidity in typical USA kitchen environments • Failed NTC thermistor component • Control panel calibration drift • Power surge damage to sensor circuitry affecting 120V/240V electrical systems • Water damage to sensor connections from ice maker or water dispenser lines
✅

Safety Checks You Can Do

    • Verify the circuit breaker serving your refrigerator is in the ON position; if tripped, reset it and monitor for recurrence • Inspect the refrigerator door gasket to ensure it closes completely and creates a proper seal • Check that the refrigerator door is fully closed and no items are obstructing it • Verify control panel settings are correct for your desired temperature range (typically 35-38°F for refrigerator, 0°F for freezer) • Allow the refrigerator 30 minutes to stabilize temperatures after initial setup or power restoration • Unplug the refrigerator from the wall outlet for 60 seconds, then plug it back in to reset the control board • Ensure air vents inside the refrigerator and freezer are not blocked by food items • Check that the refrigerator is not in demonstration or service mode if recently installed
⚠️

NOTE!

If the error code persists, call to schedule your service

Need Professional Assistance?

Our expert technicians are ready to help you with any service needs.

📞 Schedule Service 🔍 Contact Us