Book Now

Asko Washer Error Code E4

Error code E4 on Asko washers sold in the USA typically indicates a water supply issue or failure to detect adequate water entering the drum within the expected timeframe. This error prevents the wash cycle from proceeding to protect your appliance from running dry.

Home Services
⚠️

Problems You May Notice

    • Washer stops mid-cycle and displays E4 error code • Drum does not fill with water despite cycle starting • Water inlet appears weak or no water flowing into washer • Error code appears during the wash or rinse phase • Washer beeps and halts all operations • Display screen shows E4 and may not allow cycle to continue
🔧

Possible Causes

    • One or both water supply valves (hot and/or cold) are turned off or partially closed at the wall connection • Water inlet hoses are kinked, crimped, or blocked by debris or mineral buildup • Clogged water inlet filters inside the washer connection ports • Low water pressure from your home's main water supply line • Faulty water inlet valve solenoid preventing proper water flow • Door latch switch not engaging properly, preventing water fill • Control board malfunction failing to open water inlet valves • Defective water level sensor providing false readings to the control system • 120V/240V electrical supply issue affecting solenoid valve operation
✅

Safety Checks You Can Do

    • Check your home's electrical circuit breaker panel and ensure the breaker for your Asko washer is in the ON position; if tripped, switch OFF then back ON • Verify both hot and cold water supply valves under your sink or behind the washer are turned fully counterclockwise to the OPEN position • Inspect both water inlet hoses at the back of the washer for any visible kinks, bends, or pinching; straighten any hoses that appear crimped • Look at the water inlet filter screens (small mesh filters at the connection points where hoses attach to the washer) for debris or mineral deposits; if accessible and dirty, gently rinse under tap water • Check your home's water supply by running water at a nearby faucet to confirm adequate water pressure is available • Ensure the washer door is closing completely and latching with an audible click • Verify the correct wash cycle and water level settings are selected on the control panel • Power reset the washer by switching off the circuit breaker for 60 seconds, then switch it back ON to allow the system to reinitialize • Run a test cycle with just hot water or cold water selected (try each individually) to isolate whether one water line has an issue • Consult your USA Asko washer manual for the specific location of inlet hose filters and how to safely access them for cleaning
⚠️

NOTE!

If the error code persists, call to schedule your service

Need Professional Assistance?

Our expert technicians are ready to help you with any service needs.

📞 Schedule Service 🔍 Contact Us