Error code E15 indicates a water inlet or fill valve issue on your Asko washer. This error typically means the washer is not receiving adequate water supply during the fill cycle, which prevents the wash cycle from proceeding normally.
• Washer stops mid-cycle and displays E15 error code on control panel
• Wash drum does not fill with water or fills very slowly
• Water does not reach the appropriate level for the selected wash program
• Error appears immediately after starting a wash cycle or during the fill phase
• Washer beeps or sounds an alarm when error occurs
• Control panel becomes unresponsive after error displays
🔧
Possible Causes
• Water inlet valve is partially or fully clogged due to mineral deposits or sediment from water supply lines
• Hot and cold water supply valves behind washer are turned off or not fully open
• Kinked or pinched water inlet hoses restricting water flow
• Water pressure in home is too low (below 20 PSI minimum required)
• Faulty inlet valve solenoid preventing valve from opening properly
• Clogged inlet filters inside the washer connection ports
• Disconnected or damaged water supply hoses
• Circuit breaker has tripped affecting washer's electrical supply
• Control board malfunction preventing fill valve activation
✅
Safety Checks You Can Do
• Check the circuit breaker serving your Asko washer in your home's electrical panel to ensure it has not tripped; flip to OFF and back ON if needed
• Verify both hot and cold water supply valves located behind the washer are fully open by turning counterclockwise
• Inspect both water inlet hoses for kinks, pinches, or visible damage; straighten any bent hoses carefully
• Disconnect the inlet hoses from the washer and run water through them into a bucket to confirm adequate water pressure and flow
• Check that the washer door closes completely and latches properly, as some models require proper door closure to start fill cycle
• Review the control panel settings to ensure you selected the correct wash program and temperature settings
• Perform a complete reset by turning off the power at the circuit breaker, waiting 60 seconds, then turning the breaker back on
• Allow the washer to remain unplugged for 5 minutes to clear any temporary electronic faults before attempting another cycle
• Ensure the water supply has not been shut off at the main water valve in your home
• Run a test cycle with no laundry load to isolate whether the error is load-dependent or consistent
⚠️
NOTE!
If the error code persists, call to schedule your service
Need Professional Assistance?
Our expert technicians are ready to help you with any service needs.
