Asko Washer Error Code E18

⚠️

Problems You May Notice

• Washer will not start a cycle • Door lock light blinks or remains illuminated on the control panel • Error code E18 displays on the digital screen • Washer may emit a beeping sound when attempting to start • Drum does not rotate when cycle is initiated • Door may not lock when close button is pressed

🔧

Possible Causes

• Faulty door latch mechanism or catch • Defective door lock assembly • Misaligned washer door preventing proper closure • Worn or damaged door seal gasket • Broken door lock switch or sensor • Debris or lint caught in door lock housing • Failed electronic door lock solenoid • Loose or corroded electrical connections to door lock assembly • Control board malfunction unable to recognize door lock status

✅

Safety Checks You Can Do

• Verify the circuit breaker for your Asko washer has not tripped; reset if necessary • Open the washer door fully and inspect the door frame and seal for any visible debris, lint, or obstructions and clean thoroughly • Close the door slowly and deliberately to ensure it latches completely with an audible click • Check that nothing is blocking the door from closing properly, such as clothing bunched in the gasket • Verify all control panel settings are correct and no buttons are stuck or pressed inadvertently • Confirm both hot and cold water supply valves behind the washer are fully open • Unplug the washer or turn off the circuit breaker for 60 seconds to perform a hard reset, then restore power • Wait 30 seconds after closing the door before pressing start, as the lock mechanism needs time to engage • Attempt to run a cycle on a different program setting to determine if the issue is cycle-specific • If error persists after these checks, contact on 844-731-2978 for Asko service technician as door lock replacement may be required

Asko Washer Error Code E18

Problems You May Notice

Possible Causes

Safety Checks You Can Do

Need Professional Assistance?