Error F6 indicates a water inlet or fill system malfunction on your Asko dishwasher. This error typically means the dishwasher is not receiving adequate water supply or is experiencing issues with the water inlet valve.
• Dishwasher does not fill with water or fills very slowly
• Cycle stops mid-operation
• Error code F6 displays on the control panel
• Water not reaching the spray arms
• Dishes remain unwashed after cycle completion
• Audible beeping or alarm sounds
• Display shows 'F6' or similar error indicator
🔧
Possible Causes
• Water inlet valve malfunction or failure
• Clogged or kinked inlet hose restricting water flow
• Main water supply valve turned off or partially closed
• Mineral deposits or sediment blocking the inlet filter screen
• Faulty water level sensor providing incorrect readings
• Door latch not engaging properly preventing cycle start
• Low water pressure from main supply line
• Defective fill solenoid valve
• Broken or disconnected water inlet hose
• Control board malfunction affecting water inlet signals
✅
Safety Checks You Can Do
• Verify the main water supply valve under your sink is fully open by turning the knob counterclockwise
• Check that the inlet hose is not kinked, twisted, or bent and is properly connected to both the dishwasher and water supply
• Inspect the inlet hose for visible cracks, splits, or damage and replace if necessary
• Ensure the dishwasher door closes completely and latches properly with an audible click
• Confirm you are using the correct detergent type and amount recommended for your Asko model
• Clean the inlet filter screen by locating where the hose connects to the dishwasher and gently removing any visible sediment or debris
• Run a hot water tap at your sink for 30 seconds before starting the dishwasher to ensure adequate water pressure
• Perform a hard reset by unplugging the dishwasher from the electrical outlet for 60 seconds, then reconnecting and attempting a new cycle
• Check that no error codes appear after reset and monitor the fill cycle for proper water intake
• If the error persists after these checks, contact on 844-731-2978
⚠️
NOTE!
If the error code persists, call to schedule your service
Need Professional Assistance?
Our expert technicians are ready to help you with any service needs.
