ERR10 indicates a temperature sensor malfunction or heating element failure in your Asko oven. This error prevents the oven from operating safely as it cannot accurately monitor or control internal cooking temperatures.
• Oven will not heat or maintain temperature
• Digital display shows ERR10 and oven locks out
• Heating elements do not glow or function
• Oven may shut off unexpectedly during cooking
• Inconsistent baking or roasting results before error appears
• Preheat cycle fails to complete
🔧
Possible Causes
• Faulty oven temperature sensor (RTD or thermostat) unable to read internal temperature
• Broken or failed heating element (bake or convection element)
• Loose or disconnected temperature sensor wiring
• Control board malfunction preventing temperature regulation
• Door latch sensor failure triggering safety lockout
• Overheating protection activated due to blocked airflow or sensor miscalibration
• Power supply issue causing irregular voltage to heating components
✅
Safety Checks You Can Do
• Power cycle the oven: Unplug from electrical outlet for 60 seconds, then plug back in to reset the control board
• Verify the oven door is fully closed and latches securely
• Check that you selected the correct cooking mode (bake, convection, etc.)
• Allow the oven to cool completely if it was recently in use
• Ensure no aluminum foil is blocking interior vents or covering racks improperly
• Confirm the oven has proper electrical power by checking other kitchen appliances on the same circuit
• Remove any obstructions from the oven cavity that may restrict heat circulation
• Consult your USA Asko manual to locate the temperature sensor access area and visually inspect for loose connections (do not disassemble)
• If error persists after these steps, contact an Asko-authorized service technician in your region
⚠️
NOTE!
If the error code persists, call to schedule your service
Need Professional Assistance?
Our expert technicians are ready to help you with any service needs.
