Error code F2 indicates a water inlet or water supply issue on your Asko dishwasher. This error means the appliance is not receiving adequate water flow or pressure to complete its wash cycle properly.
• Dishwasher fails to fill with water or fills very slowly
• Wash cycle stops or pauses unexpectedly
• Error code F2 displays on the control panel
• Dishes remain unwashed or poorly cleaned
• The dishwasher may not start the cycle at all
• Water level inside the tub is noticeably low or absent
🔧
Possible Causes
• Water inlet valve is clogged or defective
• Water supply hose is kinked, twisted, or bent
• Inlet hose screens or filters are blocked with debris or mineral deposits
• Main water supply valve to the dishwasher is partially or fully closed
• Low water pressure from your home's main water line
• Water inlet solenoid valve malfunction
• Faulty water level sensor or float switch
• Clogged or damaged inlet hose connection point
• Mineral buildup from hard water restricting water flow
✅
Safety Checks You Can Do
• Verify the main water supply valve (typically located under the sink) is fully open by turning the handle counterclockwise
• Inspect the inlet hose for visible kinks, twists, or damage along its entire length and straighten if needed
• Check that the inlet hose is not compressed behind or under the dishwasher
• Locate and clean the inlet hose screen filters at both the water supply connection and the dishwasher inlet point using a fine mesh strainer or soft brush
• Ensure the dishwasher door closes completely and latches properly with an audible click
• Verify you are using the correct detergent type and amount recommended for your Asko model
• Run a simple reset by unplugging the dishwasher from the electrical outlet for 60 seconds, then plugging it back in
• Check your home's water pressure by running a faucet near the dishwasher to confirm adequate water supply
• Run the dishwasher on a short cycle to see if the error clears after the reset
• Contact your local water utility if you suspect low water pressure in your area
⚠️
NOTE!
If the error code persists, call to schedule your service
Need Professional Assistance?
Our expert technicians are ready to help you with any service needs.
