Asko Dishwasher Error Code F5

Error code F5 on Asko dishwashers indicates a water inlet or fill system malfunction. This error means the dishwasher is unable to fill properly with water or is detecting an issue with the water supply valve.

Home Services
⚠️

Problems You May Notice

    • Dishwasher fails to fill with water during the wash cycle • Cycle stops prematurely and displays F5 error code • Water drains immediately after partial fill • No water spraying from wash arms • Error code appears repeatedly after attempting to restart • Dishwasher may make clicking or humming sounds from the inlet valve area • Dishes remain dry and unwashed after cycle completion
🔧

Possible Causes

    • Water inlet valve malfunction or failure • Kinked or pinched water inlet hose • Clogged water inlet filter screen (located at the connection point) • Main water supply valve to dishwasher is closed or partially closed • Water pressure too low for proper fill detection • Faulty water level sensor • Door latch not fully engaged, preventing fill cycle initiation • Float switch stuck or malfunctioning • Damaged or loose water inlet hose connection • Control board issue preventing valve activation

Safety Checks You Can Do

    • Verify the main water supply valve under the sink is fully open by turning it counterclockwise • Inspect the inlet hose for kinks, bends, or damage and straighten as needed • Check that the inlet hose connections are tight at both the water source and dishwasher • Locate the inlet filter screen (typically at the water inlet connection) and rinse it under running water to remove debris or mineral buildup • Ensure the dishwasher door is closing completely and latching with an audible click • Confirm you are using the correct dishwasher detergent (not hand soap or laundry detergent) • Empty the dishwasher completely and run it empty to observe if water enters the tub • Reset the dishwasher by unplugging it from the electrical outlet for 60 seconds, then plugging it back in • Run a test cycle to determine if the error code has cleared • Check water supply line for any leaks or water pooling under or near the dishwasher
⚠️

NOTE!

If the error code persists, call to schedule your service

Need Professional Assistance?

Our expert technicians are ready to help you with any service needs.