Error code F2 indicates a heating malfunction or temperature sensor fault in your Asko dryer. This error prevents the dryer from reaching proper drying temperatures and will halt the cycle to protect your appliance.
• Dryer stops mid-cycle and displays F2 error code
• Clothes come out damp or wet despite running a full cycle
• No warm or hot air blowing from dryer vent
• Dryer runs but fails to heat
• Error code appears immediately after starting a cycle or after several minutes
• Heating element may click on and off intermittently
🔧
Possible Causes
• Faulty thermal fuse that has blown and interrupted heating circuit
• Defective heating element that has failed or burned out
• Malfunctioning temperature sensor or thermistor providing incorrect readings
• Blocked exhaust vent restricting airflow and triggering thermal shutoff
• Lint accumulation around heating element or sensor reducing efficiency
• High-limit thermostat tripped due to restricted airflow
• Defective door latch switch preventing proper cycle operation
• Wiring issues or loose electrical connections to heating components
• Control board malfunction preventing power delivery to heater
✅
Safety Checks You Can Do
• Clean the lint filter thoroughly before each use and inspect for damage or tears
• Check the exterior dryer vent hood for blockages, lint buildup, or bird nests
• Trace the vent hose from dryer back to wall outlet and ensure it is not kinked, crushed, or obstructed
• Verify the dryer door closes completely and latches securely
• Confirm you selected the correct heat setting for your load (not Air Dry)
• Ensure adequate space around the dryer for proper ventilation and airflow
• Unplug the dryer from the electrical outlet for 60 seconds, then plug back in to reset the control panel
• Visually inspect the vent hose for holes, damage, or disconnection at both ends
• Run a test cycle on the highest heat setting with an empty dryer to isolate the issue
• Contact a certified Asko technician if error persists after performing these checks, as internal components may require professional replacement
⚠️
NOTE!
If the error code persists, call to schedule your service
Need Professional Assistance?
Our expert technicians are ready to help you with any service needs.
