Error code F8 on Asko dryers indicates a heating or temperature sensor malfunction that prevents the dryer from reaching or maintaining the proper drying temperature. This error typically requires professional service to resolve safely.
• Dryer runs but produces no heat or significantly reduced heat
• Clothes remain damp or wet after a complete cycle
• Dryer stops mid-cycle unexpectedly
• Display shows F8 error code
• Dryer may emit a beeping sound when error occurs
• Temperature selector settings appear to have no effect
🔧
Possible Causes
• Faulty heating element that has burned out or failed
• Malfunctioning thermal sensor or temperature sensor
• Defective thermostat not reading temperature correctly
• Blocked or restricted airflow preventing proper heat circulation
• Lint accumulation on heating element or vents
• Damaged wiring or loose connections in heating circuit
• Defective door latch switch preventing heat activation
• Control board malfunction affecting heating system signals
✅
Safety Checks You Can Do
• Unplug the dryer from the electrical outlet for 60 seconds, then plug it back in to reset the control board
• Remove and thoroughly clean the lint filter with a brush to remove trapped lint and debris
• Check the exterior vent hood for blockages or lint buildup and clear any obstructions
• Inspect the entire vent hose from dryer to wall for kinks, pinches, or disconnections and straighten as needed
• Verify the dryer door closes completely and latches firmly without forcing
• Confirm you are using the correct heat setting for your load type
• Ensure the area around and behind the dryer is clean and has proper ventilation clearance
• Check that the dryer is plugged into a properly grounded outlet with adequate power supply
⚠️
NOTE!
If the error code persists, call to schedule your service
Need Professional Assistance?
Our expert technicians are ready to help you with any service needs.
