Book Now

Asko Dishwasher Error Code F44

Error code F44 indicates a heating element or temperature sensor malfunction that prevents the dishwasher from reaching and maintaining the proper water temperature needed for optimal cleaning cycles. This error stops the wash cycle and requires diagnostic attention to restore normal operation.

Home Services
⚠️

Problems You May Notice

    • Dishwasher stops mid-cycle and displays F44 error code on control panel • Water temperature remains cold or lukewarm throughout the wash cycle • Dishes come out inadequately cleaned or with residue • Heating element fails to activate during normal operation • Control panel becomes unresponsive or locks during cycle • Error code persists even after attempting to restart the appliance • Faint buzzing or clicking sounds may be heard from heating element area
🔧

Possible Causes

    • Faulty heating element that has burned out or lost electrical continuity • Defective temperature sensor (thermistor) providing incorrect readings to control board • Broken wire or loose connection between heating element and control circuit • Failed control board unable to regulate 240V power to heating element • Mineral buildup or sediment blocking heating element efficiency in hard water regions • Tripped thermal overload breaker on heating element due to power surge • Damaged inlet water valve preventing proper hot water supply from household line • Faulty heat relay on main PCB board
✅

Safety Checks You Can Do

    • Check your home's circuit breaker panel and ensure the dishwasher breaker (typically 15-20 amps for USA models) is in the ON position; flip it OFF then back ON if tripped • Verify the dishwasher door closes completely and latches properly, as incomplete closure can trigger error codes • Review the selected wash cycle on your control panel and confirm it's appropriate for your load; select a standard cycle and try again • Allow the dishwasher to cool for 30-45 minutes, then attempt to reset by turning OFF the dedicated circuit breaker for 60 seconds and turning it back ON • Check your home's water heater is functioning and set to 120°F (48°C); if water heater is malfunctioning, address this first • Inspect the dishwasher inlet hose connections at the back for kinks, pinches, or damage that could restrict hot water flow • Ensure the dishwasher is level and not tilting, as improper leveling can affect sensor performance • If error persists after reset, document the error code occurrence and contact a qualified Asko service technician, as this typically indicates internal component failure requiring professional repair
⚠️

NOTE!

If the error code persists, call to schedule your service

Need Professional Assistance?

Our expert technicians are ready to help you with any service needs.

📞 Schedule Service 🔍 Contact Us