Error code F15 on Asko dryers sold in the USA indicates a heating or temperature sensing malfunction. This error typically means the dryer is unable to reach or maintain the proper drying temperature needed to complete the cycle.
• Dryer runs but does not heat clothes
• Clothes remain damp after a complete cycle
• Error code F15 displays on the control panel
• Dryer may stop mid-cycle
• Extended drying times without heat generation
• No warm air exiting the vent
• Cycle may automatically terminate
🔧
Possible Causes
• Faulty heating element or heating coil failure
• Temperature sensor malfunction or disconnection
• Clogged or blocked exhaust vent reducing airflow
• Lint buildup restricting heat circulation
• Kinked or damaged vent hose preventing proper venting
• Door switch failure preventing heat operation
• Thermal fuse blown due to excessive heat buildup
• Wiring or connection issues to heating components
• Control board failure affecting temperature regulation
• Inadequate airflow from blocked intake or exhaust paths
✅
Safety Checks You Can Do
• Clean the lint filter thoroughly before each use and check for lint accumulation
• Inspect the exhaust vent hose for kinks, bends, or blockages and straighten as needed
• Verify the vent hose is not pinched behind or under the dryer
• Ensure the dryer door closes completely and latches properly
• Check that the correct drying cycle and heat setting have been selected
• Disconnect the dryer power for 60 seconds then reconnect to reset the system
• Clean the exterior vent hood to ensure lint is not blocking outside air intake
• Inspect the lint trap area for excess lint or debris accumulation
• Confirm adequate space around the dryer for proper ventilation
• Verify no objects are blocking the exhaust vent opening outside your home
⚠️
NOTE!
If the error code persists, call to schedule your service
Need Professional Assistance?
Our expert technicians are ready to help you with any service needs.
