ERR8 indicates a temperature sensor or thermal detection fault in your Asko oven. This error prevents normal oven operation as the appliance cannot accurately monitor internal temperature for safe cooking.
• Oven will not heat or reach desired temperature
• Error code ERR8 displays on the control panel
• Oven cycles on and off repeatedly
• Heating elements may not activate
• Cooking function is completely disabled
• Temperature display may show incorrect or erratic readings
🔧
Possible Causes
• Faulty or disconnected temperature sensor probe
• Damaged temperature sensor wiring or connector
• Control board malfunction preventing sensor signal interpretation
• Overheating protection triggered by excessive internal temperature
• Failed heating element causing temperature regulation failure
• Power supply voltage fluctuation affecting sensor circuitry
• Accumulated grease or debris interfering with sensor function
✅
Safety Checks You Can Do
• Unplug the oven from the electrical outlet for 60 seconds, then plug it back in to reset the control board
• Ensure the oven door is completely closed and latched firmly
• Verify you have selected the correct cooking mode before starting
• Allow the oven to cool completely if it was recently used, then attempt operation again
• Confirm adequate electrical power is reaching the outlet using another appliance
• Check that aluminum foil or cookware is not blocking interior vents or the temperature sensor
• Inspect the oven interior for any visible damage to sensor probes or wiring
• Review your user manual to confirm the sensor location and ensure it is not physically obstructed
⚠️
NOTE!
If the error code persists, call to schedule your service
Need Professional Assistance?
Our expert technicians are ready to help you with any service needs.
